HealthFX America Healthmax Pro Multifunction Home Gym

HEALTHMAX PRO

HF015AC ASSEMBLY INSTRUCTIONS

1. MAIN FRAME ASSEMBLY
Place the main vertical column (A) in the upright position as shown in FIG. 1. Attach the main column to the front floor bar assembly (B), using four hex head screws (C) with four small washers (V). Tighten with the tools provided in the small parts box but not securely. Repeat for the rear floor bar assembly (G). Now tighten all hex head screws securely.
Locate the spring pin knob (MM) and open end wrench in the small parts box. Screw in the spring pin knob (MM) into the adjustment pipe as shown in Fig.1. Tighten securely by placing the wrench over the grooved edge of the black body of the knob. Do not tighten with the knob itself.

2. INSTALL THE BENCH AND BACK REST

Insert the folding bench pipe (JA) into the adjustable support pipe (AD) as shown in FIG. 2. Loosen the spring pin knob (MM ) by turning it all the way counter clockwise. Pull out on the spring pin knob (MM) and let the pipe snap into place at the first option hole. Tighten the knob and note that pipe (JA) is now secure. Unfold the rear bench legs (L) and extend all the way to the rear. Insert the pipe (JA) inside the bench support pipes and attach using bolt (ZZ) with two washers (E) and nut (F). Do not over tighten.

You can set the height of the bench to any of 3 positions. Practice adjusting the height of the bench loosening the knob, pulling out the spring pin, and raising or lowering the bench until it snaps into place. After it snaps into place then tighten the knob. Note that the folding legs (L) have rolling wheels to allow the bench to move forward or backward to keep the folding bench pipe (JA) in a vertical position and prevent binding. Insert lock pin (H) into the front bench bracket.

Attach the HealthMax Pro back pad (PB) to the main vertical column using two screws (AY) and washers (AZ) with the fastening tool provided in the small parts box.

Home

Previous

Next